Rev: 10.24.19
Page 8
CCD-0002685
Awning Wiring
The Edge Awning motors come stock with an internal 6A auto-reset breaker. If this breaker trips, it will
take approximately 30 seconds to reset. LCI recommends the awning be wired with a 15A auto-reset
circuit protector. If the circuit protector trips, it will take approximately 30 seconds to reset. All wire shall
be 14 AWG or higher as necessary to provide 11.5V minimum at all times to the LCI-supplied power cable
connection.
1.
Pull the wires from the unit through the support arm assembly. These wires may be located at the
bottom or the top of the support arm assembly.
2.
Connect wiring from the unit to the switch and the awning drive head. See Wiring Diagram (Fig. 11).
3.
Check the switch. If the awning is running in reverse of what the switch indicates, reverse the wires.
