![Lippert Components 140-1229 Owner'S Manual Download Page 8](http://html.mh-extra.com/html/lippert-components/140-1229/140-1229_owners-manual_1927317008.webp)
Rev: 11.23.22
Page 8
CCD-0004307
Description
Probable Cause
Corrective Action
Touch Pad will not
turn ON
Coach ignition not in
run position
Turn on the ignition and start the coach. The
engine must be running for the jacks to operate.
Blown fuse or tripped
circuit breaker
Replace fuse or reset breaker
Auto Shut Off
Push On/Off button to turn the control back ON.
Jacks will not extend.
Pump is not running
Blown fuse or tripped
circuit breaker
Replace fuse or reset breaker
Batteries are weak
Turn on the ignition and start the coach. Wait a
few minutes to allow the batteries some time to
charge. The engine must be running for the jacks
to operate.
Jacks will not extend
(or are extending
slowly), pump is
running
Fluid level low
Fill tank to proper level with automatic
transmission fluid, see tip sheet 140.
Batteries are weak
Turn on the ignition and start the coach. Wait a
few minutes to allow the batteries some time to
charge. The engine must be running for the jacks
to operate.
Jacks will not retract
fully
Air in the system
Check for coils in hose. Remove the coil if
present then extend all jacks to full extension,
then retract fully. Repeat 4 cycles waiting a few
minutes between cycle
Troubleshooting
The following chart contains troubleshooting tips if your system is not operating properly, and the touch
pad is not giving you a trouble code.