Lipco UFD 100, Translation Of The Original Instructions, Page: 12 / 24

Original instructions Reversing Harrow UFD 100/110/120/140
12 - 24 100102-02-EN BA UFD 100_110_120_140 / 09.08.2019
8. Preparation
•
Before using the unit, check whether all accident protection
devices on tractor, machine and joint shaft are attached correctly
and are in functioning order. Before operating the unit, it is
imperative to replace or install damaged or missing components!
•
Check the oil level on the angular gear!
•
Check the grease level in the chain case!
•
Make sure that all screws are tightened, and all elements are in
perfect working order!
Attention:
Depending on availability,
LIPCO Reversing Harrow can be
equipped with cardan shafts from different manufacturers
(Walterscheid or Wiesler ..etc.).
The friction clutch built into the cardan shaft is a safety
component and must be handled with care.
•
When using the LIPCO Reversing Harrow machine for the first
time, the PTO shaft operating instructions attached to the PTO
shaft must be removed and read carefully.
When the LIPCO Reversing Harrow is used for the first time /
after a longer stop, the friction clutch must be checked for
functionality.
To do this, the friction clutch must be released, turned by hand
and then tensioned again.
Further details on checking the friction clutch can be found in the
operating instructions of the respective manufacturer.
Note:
If the friction clutch does not function properly, it may cause
serious damage to the machine if it is not released in the event
of an overload.