Lipco UFD 100, Translation Of The Original Instructions, Page: 14 / 24

Original instructions Reversing Harrow UFD 100/110/120/140
14 - 24 100102-02-EN BA UFD 100_110_120_140 / 09.08.2019
10. Connection of the machine to the tractor
•
Before starting the machine and the tractor, check road and
operating safety!
•
Persons must never be allowed to stand between the tractor and
the attachment unit without having secured the vehicle against
rolling away by means of the locking brake and / or wheel cocks!
•
Never stay in the rotating and pivoting area of the unit!
•
In the transport position of the unit, sufficient lateral arresting of
the tractor three-point suspension has to be ensured, in order to
avoid lateral swing-out of the machine!
•
Before attaching and removing the unit to the three-point
suspension, place the operating device in the position in which
unintentional lifting and lowering is excluded!
11. Connecting the universal joint shaft
•
Only mount and dismount the universal joint shaft when the
power takeoff shaft and the engine have been turned off and the
ignition key pulled!
•
When the unit has been coupled to the tractor, check the exact
length of the universal joint shaft.
Very important : Highest possible overlapping has to be aimed
at. During operation, the maximum extension of the joint shaft
should be half the sliding profile overlapping (Fig. 3). When
connecting to different tractors, the length must be checked
again.
•
Attention!
Press
sliding pin and
simultaneously push the joint
shaft onto the power take-off
shaft until the sliding pin
engages.
Fig. 4