Instructions
Compact disc mower KSM 130
18 - 22
140050-01-EN BA KSM 130 / 04.06.2020
14. Instructions for repair shops
Repair of the cutter disc bearing
Attention!
Here, too, it is imperative to use original spare parts only (owing to
special tolerance).
After removing the cutter discs, the bearing housing (8) can be
removed from the cutter bar toward the top by unscrewing the nut
(11). No further dismounting of the cutter bar necessary.
Angular ball bearing:
The drive cutter disc located directly under the angular gear is
housed on 2 angular ball bearings (7). (For all other cutter discs,
deep groove ball bearings must be used.) The angular ball bearing
must be mounted in the bearing housing (8) such that the bearing
inner rings face each other with their smaller side (10).
Fig. 7
Summary of Contents for KSM 130
Page 22: ...22 22 Design mail bauer ib com...
