Instructions
Compact disc mower KSM 130
17 - 22
140050-01-EN BA KSM 130 / 04.06.2020
•
For the cutter bar, high-grade mineral gear oil SAE 80 or 90 must
be used.
Filling amount:
Oil in the angular gear:
•
Check the oil level in the angular gear. This is done by tilting the
unit by 90 degrees, so that the bore for the oil charging screw of
the angular gear points upwards.
Oil filling level of angular gear: 2 -3 cm
Attention: Support the machine sufficiently against tilting.
•
First oil change after 30
–50 operating hours and then every 200
operating hours, but at least once a year. Use gear oil SAE 90.
Filling amount: 0.3 L
•
However, it is extremely important to observe the above-
mentioned oil change intervals!
•
The used oil must be disposed of in accordance with current legal
regulations.
13. Cutting operation faults
Striations, Marcelling
•
Resharpen blades or use new ones. Ensure correct mounting with
respect to clockwise/counterclockwise rotation.
•
Set cutter bar inclination!
•
When doing so, observe the safety regulations in chapter 5. When
replacing the blades, follow the instruction given in chapter “11.
Maintenance”.
Summary of Contents for KSM 130
Page 22: ...22 22 Design mail bauer ib com...
