Operating Manual
Cross-flow fan unit type GSG-NV1 / 2
23 - 64
010980-26-E BA GSG-NV1_2 / 23.03.2012
13. Attachment of the universal joint shaft
Prior to connecting or detaching the universal joint shaft, always
make sure to switch off the power take-off shaft and motor and to
remove the ignition key!
Press push pin and push the universal joint shaft onto the power
take-off shaft until the pin locks into place! (Fig. 16)
Fig. 15
Fig. 16
After connecting the
LIPCO GSG-NV
to the tractor, check the
length of the universal joint shaft.
Caution!
Maximum overlapping is desirable. The universal joint shaft must
not be pulled apart more than half of the overlap of the sliding
profile. (See Fig. 15)
When connecting to a different tractor, check the length again!
When the machine is not in use, the universal joint shaft can be
inserted in the bracket provided for protection.
When connecting the universal joint shaft to the machine, make
sure that the protective cover completely covers the universal
joint shaft guard in all operating positions!
For your personal safety it is important that damaged or worn
protective devices be replaced immediately.