Lipco GSG-AN-VM, Translation Of Original Instructions, Page: 30 / 72

Operating instruction Saddle-mount fan unit with tank trailer GSG-AN-VM
30 - 72 011170-05-EN BA GSG-AN-VM / 2019-01-16
17. Driving on roads with the GSG-AN-VM
•
Special points to be observed when driving on roads!
Lights:
•
The lights of the tank trailer
must be properly connected to
the towing vehicle to ensure
safe operation in traffic. (Fig.
20)
Connect lights
via the 7-pin 12V plug on the
tractor.
Fig. 20
•
The fan units must be in the inner position, i.e. completely
pushed together, and the hydraulic drive must be switched off.
To prevent the fan units from moving apart while driving, manual
shut-off valves are built into the pressure lines of the hydraulic
cylinder that is pressurized when extending the fan units. These
valves must be closed when driving on roads.
Shut-off valve:
•
The shut-off valves must al-
ways be closed when driving
on roads. (Fig. 21)
•
To spray at a later time, the
valves must be opened again.
The shut-off valves are located
in the pressure lines and are
marked with a red cap.
Fig. 21
to tractor
open