Lionelo sander, User Manual

Page: 16 / 120

‑ 16 ‑ EN
upper part of the harness belt through the guide in the headrest from the car belt
retractor side. Make sure the belt is in the belt guide and is not twisted. Tighten
the belt by Pulling its breast part towards the belt retractor. Make sure the hip
belt goes through the center of the child’s collarbone. If the belt is too close to
the child’s neck, adapt it to the headrest again (fig. 24).
Installation for Group II and III (15-36kg) with safety belts
Remove safety belts of the safety seat (see instructions below). In this position
the safety seat must be in forward-facing position. Place the safety seat on the
car seat so that its backrest fits the backrest of the car seat tight. Place the child
in the safety seat. Set a relevant height of the headrest (see instructions above).
Carry the car belt in front of the safety seat. Fasten the belt clamp in the buckle
and position the hip belt in the lower guides. Pull through the upper part of
the harness belt through the guides in the headrest from the car belt retractor
side. Make sure the belt is in the belt guide and is not twisted. Fasten the belt
by pulling its breast part towards the belt retractor. Make sure the harness belt
goes through the center of the child’s collarbone. If the belt is too close to the
child’s neck, adapt the headrest again (fig. 24).
See fig. 25-The safety seat must be in position 1
Disassembly of 5-point safety belts
Slacken belts off and open the harness clamp. Pull out the buckle from the safety
belts (in the back of the safety seat). Pull out arm belts from the safety seat. Pull out
the crotch belt from the metal buckle under the base of the safety seat, and pull it by
taking out the entire crotch belt along with the buckle from the hole (fig. 26). To mount
five-point safety belts in the safety seat, follow the same actions in reversed order.
Removing a cover
Remove 5-point safety belts in accordance with the instructions above. Undo
an additional headrest cushion. To remove a cover, start from the bottom of the
safety seat and end up with its headrest (fig. 27).
Cleaning
Use natural detergents and warm water (below 30°C). Do not wash in the washing
machine. Do not swirl and squeeze. Note: Extensive scrubbing may damage the