LINTECH
–
1 avenue de Norvège
–
91140
–
Villebon sur Yvette
Tél : 01 64 86 70 90
–
Fax : 01 64 86 70 80
Icons definitions
7.
: video mode
8.
: The microscope is recording
9.
: The microscope is taking a picture
10.
/
: with/without TF card
11.
: Still image mode
12.
: review mode
Quick start
1.
To use the microscope without the need for a computer, plug the power block in to an
electrical outlet. Then connect every part via the switch cable (Please see the diagram at
part “Connect”).
2.
Then press and hold the Power button(number
①
from the picture
“Buttons”
)
underneath the display until the display turns on. (It may turn on automatically, and it
’
s
totally fine.)
*Troubleshooting
If the display freezes, locate the “
reset
”
hole on the back of the monitor (see part
“Connect”). Use a narrow object
such as an unfolded paperclip to depress the button
located inside. This resets all settings to their factory values and restarts the display . It
does not erase saved images or video.
Adjusting the Magnification and Focus
Use the large knobs on the optical bracket to raise or lower the optical stack to the
desired height. The lower the height, the greater the magnification, but be careful not to
let the bottom of the stack contact the object being imaged. (Note that you may need to
reposition the spotlights as you move the stack up or down.)
Turn the Focus controller(number
⑨
from the picture
“Buttons”) to focus the image.
To increase the digital magnification, press and hold the Up button(number
③
/
○
,13
from the picture
“Buttons”) until the
desired digital magnification(up to an additional 4x
beyond the optical magnification) is reached. Use the Down(number
④
/
○
,11
from the
picture
“Buttons”) button to decrease the digital magnification.
While ambient light may be adequate for many circumstances, the spotlights or bottom
