Linsar WM800, User Manual

Page: 28 / 83

28
• Your machine may have either a single inlet
(cold) or double water inlets (cold/hot) based on its
specifications.
A white-capped hose should be connected to the
cold water inlet and a red-capped hose to a hot
water inlet (applicable for machines with double
water inlets).
• To eliminate water leakages in points of contact,
1 or 2 nuts are provided in the hose package (ap -
plicable for machines with double water inlets).
Fit these nuts to the ends of new water inlet hoses
on the tap end of the hose.
• Mount new water inlet hoses to a ¾ ˝, threaded
faucet.
• Connect the white-elbow end of the water inlet
hoses to the white-filtered water inlet valve on the
rear side of the machine and the red-elbow end to
red-filtered one (applicable for machines with dou -
ble water inlets).
Tighten plastic parts of the junctions using your
hand. In uncertain conditions, have the connection
works done by a qualified plumber.
• Flow of water with pressure of 0,1-1 Mpa will
allow your machine to operate more efficiently.)
(0,1 Mpa pressure means that more than 8 litres
of water will flow through a fully-tapped faucet per
one minute.)
CHAPTER -3: INSTALLATION
(WATER INLET HOSE CONNECTION)
3/4”
10
mm