Connecting
Connect each left and right channel on the Majik DS-I to the equivalent terminal on
1.
your loudspeaker using your preferred connection method (spade / banana plug / bare
wire) and ensuring a good tight connection is made in each case
Connect the Majik DS-I
2.
Ethernet
socket to your network using a standard Ethernet
cable
Connect any additional source components to the back panel using your preferred
3.
connection method (phono or balanced) - use socket
4/PH
for any turntable you wish
to connect (and
do not connect
line level source components to this socket)
Your Majik DS-I is configured as an MM (Moving Magnet) phono stage as default -
•
please contact your Linn Specialist if you wish to change this to MC (Moving Coil) or
convert socket
4/PH
to line level
Connect your mains cable but do not power on the unit yet
4.
If you have a NAS or ripping NAS then you should also ensure this is connected to
5.
your network and powered on (
see
www.linn.co.uk/nas
for more info)
Thank you for purchasing the Linn Majik DS-I player. This guide provides basic unpack-
ing and connecting information to get you started - contact your Linn Specialist for full
installation support.
IMPORTANT:
Please refer to the printed Safety Information booklet for important safety information
and the online manual available at
www.linn.co.uk/majikdsi
for full instructions on
using your Linn Majik DS-I player.
Unpacking
Remove product from packaging and place on a flat surface
•
Please retain all packaging for future transport of Majik DS-I
•
Contents
1 x
•
Majik DS-I player
1 x mains lead
•
1 x luminous infra-red (IR) handset (with 2 x AAA batteries)
•
1 x Safety Information booklet
•
Positioning
Place unit on a flat, stable and rigid surface
•
Place unit within range of your network router or switch
•
IMPORTANT:
Linn recommend the use of separate dedicated network components, including
router, switch and wireless access point (if required for wireless control). Alterna
-
tively, a dedicated integrated router/switch/wireless device is preferable to simply
connecting the unit directly to your home broadband router. Linn do not recom-
mend a wireless connection between DS player and network. See
www.linn.co.uk/networks
for more info
Avoid positioning the unit in direct sunlight as this can interfere with the infra-red
•
(IR) sensor on the front panel
Do not stack components and avoid placing near other heat sources
•
Do not block vents or site the unit in a cabinet which prevents air flowing from front
•
to back
Allow at least 4” (10 cm) all the way around the unit for air circulation
•
MAjIk DS-I
QUICkSTART
