Installation Guide Linear Motors
ENG
Page 18 / 32
P10-54 / P10-54-D24/25/25S
NTI AG / LinMot
5.1.2 Mounting
1. Dismounting front bearing set
Remove the end piece and the bearing
bushing at the front end of the stator.
Note!
With the stator P10-54x120 there is
only 1 bearing bushing for the whole length.
2. Mounting front bearing set
The bearing bushing is pushed in as far as
it will go. Then screw the end piece
together with the 2 pan-head screws.
Tightening torque:
1.2 Nm
The pan-head screws are already coated
with Tuflok.
3. Dismounting rear bearing set
Remove the end piece and the bearing
bushing at the front end of the stator.
Note!
With the stator P10-54x120 there is
only 1 bearing bushing for the whole length.
4. Mounting rear bearing set
The bearing bushing is pushed in as far as
it will go. Then screw the end piece
together with the 2 pan-head screws.
Tightening torque:
1.2 Nm
The pan-head screws are already coated
with Tuflok.
