E1400 V2 Installation Guide
7.4 X2
X2
Motor Phases
PE:
Protective Earth
W:
Motor Phase W
V:
Motor Phase V
U:
Motor Phase U
T+:
Temperature Sensor KTY+ (on DC- voltage level!)
T-:
Temperature Sensor KTY- (on DC- voltage level!)
The Shield of the motor cable has to be mounted with a surface as large as possible (low
ohm, low impedance).
Use an EMC shield clamp for fixing (LinMot MC10-EMV/14-D Art. Nr. 0150-3631)
Attention:
An isolated thermistor is necessary! Especially LinMot D01 and D02
Motors can not be connected!
Screw Terminals:
- Tightening torque: 0.7 - 0.8 Nm (6.2 – 7.0 lbin)
- Use a cross-head screw driver (PH1)
- Use 60/75°C copper conductors only
- Conductor cross-section: 0.25 – 4 mm2 (depends on Motor current) / AWG 24 -12
- Stripping length 10mm
7.5 X32
X32
Motor Brake
X32:
Brake-
Brake+
The brake is powered internally by 24VDC from X4!
It's suitable for driving inductive loads up to 1.5A (preliminary).
The V1 Drives had a separate connector for the brake supply (X31).
NTI AG / LinMot
®
www.LinMot.com
Page 11/27