Linhai M565Li T3 EFI, Service Manual, Page: 70 / 338

CHAPTER 3 ENGINE
M565Li T3 EFI SERVICE MANUAL 20.0
CHAPTER 3 ENGINE PAGE. 3- 22
●
Take out the feeler gauge, measure the
clearance. If the clearance is incorrect, re-
peat the above steps until the proper
clearance is obtained.
Inspect initially at 20 hours run-in and
every 50 hours or 1500km thereafter.
●
If the clearance is incorrect, bring it into
the specified range using the special tool.
Loosen valve adjust bolt and nut, insert a
feeler gauge between the valve stem end
and valve adjusting bolt (0.06mm
thickness for intake valve, 0.08mm
thickness for exhaust valve), tighten valve
adjust bolt, make sure it slightly contacts
the feeler gauge, tighten bolt and nut.
Locknut
：
12 N
·
m
Tools
：
Valve adjuster
Feeler gauge Material
：
Thread Locker
Caution:
Securely tighten the locknut after
completing adjustment
3.2.4 ENGINE IDLE SPEED
●
Install cylinder head, speed sensor
Start the engine and warm it up for
several minutes, measure engine speed
with a tachometer.
Engine idle speed
：
1500r/min
±
100r/
min
1
2
4
3
1-Valve Adjust Screw
2-Valve clearance
3-
Valve