Lingenfelter NCC-001, Installation And Operating Instructions Manual

Page: 96 / 171

Lingenfelter NCC-001 Nitrous Control Center Installation and Operating Instructions 95
From the Status screen , press the "Timer" button. The "Hysteresis%" option is found in the "RPM Based Setup"
dialog box under the "Options" Tab. Click the "UP" and "DOWN" arrow buttons or type in any numeric value in
the valid ranges shown above.
7.4 Shift Setup Menu
The following options and settings can be found in the Shift Setup Menu.
Shift RPM
This setting controls the RPM to activate the +12 volt Shift Light output on the NCC-001.
The Valid Range is 1000 to 16000 RPM in 100 RPM increments.
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the Shift Setup
menu selection is highlighted and then press the “ENTER” button twice. Using the “LEFT” and ”RIGHT” arrow
buttons adjust the setting. Press the “SAVE” button to accept the new setting or press the “ESC” button to exit
with no change.
Access from the Computer Program:
From the Status screen , press the "Shift RPM" button. The "Shift RPM Default" option is found in the "Shift RPM
(s)" dialog box under the "Options" Tab. Click the "UP" and "DOWN" arrow buttons or type in any numeric value
in the valid ranges shown above.
7.5 Throttle Position Sensor (TPS) Setup Menu
The following options are found in the TPS setup menu, which can be accessed by the "SETUP" button on the
main screen of the controller or the TPS Input tab on the Setup screen of the computer software. The TPS
accepts rising or falling voltage signals. Note that the Throttle Position Sensor (TPS) and the Accelerator Pedal
Position sensor (APP) are NOT the same. While both the TPS and APP sensors function by relaying a voltage to
the ECM that translates into the degree of engagement, the measurements and their consequential voltages are