Linertec LTS-200 Series, Instruction Manual

Page: 34 / 76

31
• The 0% represents the horizontal 0, and +100% and -100% represent 45° up and down
slopes respectively.
• To return the screen from the slope (%) display to the 360° scale, also take above same
steps by entering MODE B.
• If the slope (%) exceeds [+/-] 1000%, “Out of grade range” is displayed, indicating that the
current vertical angle cannot be measured.
• When the telescope returns to a slope within slope [+/-] 1000%, the slope (%) display
returns automatically from the “Out of grade range” message to the numeric value.
5.6 Changing the horizontal angle from clockwise to counter
clockwise
Press [F5] [MODE].
Press [F2] [ANG SET] to display the ANGLE SET
screen.
Press [F4] [ ] to move the cursor to
“3. R/L REVERSE”.
Press [F5] [SELECT] to add a minus sign (-) to the
horizontal angle value as a counter clockwise angle.
• To return the horizontal angle from counter clockwise to clockwise, also take the above
same procedures, press [F5] [SELECT] to select the clockwise angle.
• When the counter clockwise horizontal angle is selected, the order of aiming at the targets
becomes the reverse (the right one first, then the left one) of the order for the clockwise
angle.