47
DO926BFK
www.domo-elektro.be
EN
5. Reverse the middle hinge. Screw the
middle hinge onto the opposite side of
the unit.
6. Carefully set the upper door back into
place, inserting in onto the middle hinge.
7. Insert the upper hinge and screw it
tightly to the top of the unit.
Middle hinge
Ensure the lower door is aligned
horizontally and vertically, so that
the seals are closed on all sides
before finally tightening the hinge.
Ensure the upper door is aligned
horizontally and vertically, so that
the seals are closed on all sides
before finally tightening the hinge.
4. Remove the lower screws and lower
hinge from the unit bottom. Reverse the
lower hinge, move and secure it with
the lower screws to the opposite side of
the unit bottom. Carefully set the lower
door back into place, inserting it onto the
lower hinge.
8. Put the hinge cover back.
9
INSTALLATION
LFC60W16_IB_160201_grace.indd 9
1/2/16 10:43 am
8. Position the upper door. Position the hinge of the upper door, fasten it with the screw and
replace the cover plate.
5. Reverse the middle hinge. Screw the
middle hinge onto the opposite side of
the unit.
6. Carefully set the upper door back into
place, inserting in onto the middle hinge.
7. Insert the upper hinge and screw it
tightly to the top of the unit.
Middle hinge
Ensure the lower door is aligned
horizontally and vertically, so that
the seals are closed on all sides
before finally tightening the hinge.
Ensure the upper door is aligned
horizontally and vertically, so that
the seals are closed on all sides
before finally tightening the hinge.
4. Remove the lower screws and lower
hinge from the unit bottom. Reverse the
lower hinge, move and secure it with
the lower screws to the opposite side of
the unit bottom. Carefully set the lower
door back into place, inserting it onto the
lower hinge.
8. Put the hinge cover back.
9
INSTALLATION
LFC60W16_IB_160201_grace.indd 9
1/2/16 10:43 am
9. With the door closed, check whether the door is aligned horizontally as well as vertically
and that the seal closes on all sides before you tighten the upper hinge completely. If
necessary, adjust the adjustable feet.
CLEANING AND MAINTENANCE
Do not use abrasive cleaning agents or solvents.
1. Disconnect the mains plug from the mains socket.
2. Take out the food and store in a cool location.
3. Clean the appliance with a soft cloth, warm water and detergent.
4. Wipe the door seal with clear water only and then wipe dry thoroughly.
5. After cleaning reconnect and adjust the temperature control knob as desired.
6. Put the food back into the appliance.
DEFROSTING
The refrigerator defrosts fully automatically.
While the cooling is running, beads of condensation or hoarfrost form at the back of the
refrigerator. This is normal. It is not necessary to wipe off the condensation or frost. The rear
panel defrosts automatically. The condensation runs into the condensation channel and is
conveyed to the cooling from where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so that the condensation can
run out.