Manual
To use the remote control to switch channels, first select the input you require and then select the output/outputs
you would like it to display on. Repeat this for multiple pictures on multiple screens. The channel switching takes
approximately 2 seconds.
Fn + Source Sel 1 = Escape system lock
Fn + Source Sel 2 = System lock. The remote control becomes inactive except for the above command.
Dip switches
Dip Switch Position
Pin #1
Pin#2
Pin#3
Pin#4
Operation mode via RS-232 Port
1
OFF (
↑
)
OFF (
↑
)
OFF (
↑
)
OFF (
↑
)
Operation mode via USB Port
2
OFF (
↑
)
OFF (
↑
)
OFF (
↑
)
On (
↓
)
Firmware update mode
3
Block A Main
On (
↓
)
OFF (
↑
)
OFF (
↑
)
OFF (
↑
)
Block B Remote
On (
↓
)
On (
↓
)
On (
↓
)
OFF (
↑
)
1. Factory default setting, all pins set to “off”. This is the default mode for RS-232 control.
2. For USB control, set Pins 1, 2 & 3 to “off” and Pin 4 to “on”.
3. Firmware update mode can only be used via RS-232 with the PC set to COM1.
a. Power off your LINDY 8x8 DVI Matrix and connect your serial cable to the RS-232 port and serial port of
your PC.
b.
Execute the firmware update program on your PC via the COM 1 port.
c.
Set Pin 1of Black A Main to the “on” position for firmware update mode.
d.
Set Pins 2 & 3 to the respective positions to assign which block is to be updated.
e.
Power on your Matrix and the firmware update program should begin the update sequence automatically. (If
the program does not start, check the cable connections).
f.
Once the firmware update sequence has completed, the screen will display “OK”, at this point turn off the
Matrix.
g.
When all updates are complete, set the dip switches to normal operation mode.
h.
Power on the LINDY 8x8 DVI Matrix.
Software installation & control
Note: before inserting either the USB or serial cable, make sure that the main dip switches are set to the correct
position. Incorrect dip switch settings will result in the DVI Matrix not being picked up on the PC com port.
1. Plug either a USB A male to female cable or serial cable in to the back of the Matrix and your computer.
2. For USB the computer will show that new hardware has been found. Click next to continue and click finish at
the end.
3. When the hardware has fully installed, insert the CD provided.
4. Open the folder “01 control program\control program 8x8 DVI matrix\8x8 DVI matrix setup” This will install the
Matrix control software.
DVI Input
mapping area
DVI Output
mapping area
Status indicator
1
2
3
4
5
6
Summary of Contents for 38088
Page 2: ......