Linde CiTi One 1150, Original Instructions Manual

Page: 42 / 70

4
Use
Assessing the load
1.3 Checking the load assessment
system
This check must be carried out regularly during
the truck’s first hours of operation and after
any use that may have resulted in exceptional
mechanical stress (e.g. a fall from a rear flap
or movement over obstacles with heavy loads)
To carry out this operation:

Weigh three known loads: x, y and z.
The weights displayed for each load should
correspond to the actual measured weight of
the load (±25 kg).
This system gives an indication of the weight
being transported. If the value indicated
by the truck seems incorrect, retake the
measurement.
If the problem persists:
1) Check the weight of the pallet with cali-
brated scales.
2) Repeat calibration using the "Resetting to
zero" function (see chapter 1.4).
3) If this is unsuccessful, please contact our
after sales service.
1.4 Resetting to zero function
This function allows you to reset to zero.
NOTE
Several rules must be observed when reset-
ting to zero:
- There should be no load on the forks
- The ground should be flat
- The lifting motor should be warm (perform a
few lifts first if necessary)
Operation:

Press the (1) button for 2 seconds

Perform 5 full lifting cycles (from lowered
forks to lifted forks). The screen will then
indicate successive lift numbers (2) from
1 to 5 as well as symbols "h" and "kg"
indicators.
38 1130 801 15 02 EN – 11/2012