27
User’s guide
Jogging allows you to move the head by pressing the direction arrow. The JOGGING group has tabs for
moving the head to the appropriate location anywhere on the table.
Jog:
The JOG keys are laid out in the manner as the table moves.
Pressing towards the centre of the JOG key makes the torch
move slowly, and pressing it towards the outside leads to a faster
movement. The JOG window is made up of three separate tabs:
• Continuous
• Incremental
•
Point.
On the bottom, is the FEED RATE OVERRIDE %. That allows you
to modify the feed speed of the active job. That function is used to
precisely adjust the feed to obtain the best possible cutting quality.
Continuous makes it possible to move the torch as long as a finger
is pressing the arrow.
Incremental Jog:
Pressing in a direction moves the torch in the same direction
while using the increment distance adjustment bar to modify the
distance.
The adjustment bar allows you to use increments from 0.000 and
0.100. You can directly enter any number in the dialogue box.
Point Jog:
Point jog allows the user to define up to where the head must
move, and from which location.
Select where you want the torch to start, what feed rate to travel
and the X/Y coordinates and press MOVE TO POSITION.
CUT TO POSITION works the same way except it will go through
the IHS sequence and fire the torch. That makes it possible to
eliminate residues and obtain perfect lines.
Jogging: