Aurora Documentation Guide
This Quick Start Guide outlines the basic steps required to setup and control the Aurora
platform. If you require assistance with Aurora or would like to review further
documentation on the Aurora platform, please see
Connecting the Aurora
●
Attach the male connector of supported LED light fixtures to one or more of the
female connectors of the Aurora LED output channels.
●
Secure the lock ring over the connection without over tightening.
●
The Aurora platform by default supports (60) sixty LED nodes on each of its (8)
eight channels, though the maximum number of fixtures may be less depending
on the power requirements of the chosen fixtures and any additional leader
cables used.
●
See Appendix - Aurora Power Best Practices
Warning
: Incorrect lighting configurations can result in damaged light strands or controller.
Warranty for Aurora may be void if the guidelines for setup configuration are not properly
followed.
●
Once the fixtures are attached the system can be powered up using the provided
IEC cable.
2
v 1.3