MC111
MAN MC111 I_E 1.1.doc
Pag. 5
www.lika.it
www.lika.biz
User manual
MC111
Description
This manual describes the MC111 display series. The
purpose of this device is to display linear or
angular displacements on industrial machines and
automation systems. The device can be connected
to standard Push&Pull incremental encoders or
magnetic sensors (A and B signals).
Chapters
1
Safety summary
2
Identification
3
Installation
4
Mounting recommendations
5
Electrical connections
6
Functions
7
Set up
8
Dimensional drawing and cut&out
1 Safety summary
For the electrical connections, we recommend to
closely follow these electrical instructions. In
particular, according to the 89/336/EEC norm on
electromagnetic
compatibility,
following
precautions must be taken:
•
Measurement system (sensor) should be
installed as close as possible to the display.
•
Always use shielded and twisted cables if
possible.
•
Avoid running the sensor cable near high
voltage power cables (e.g. drive cables).
•
Install EMC filters on sensor power supply if
needed.
•
Avoid mounting sensor near capacitive or
inductive noise sources and switching power
supplies.
•
static discharge can damage internal sensitive
electronic components. Before handling and
installing, discharge electrical
charge from your body and tools
which may come in touch with
the device.
Connect according to the chapter 5: “Electrical
connections”.
2 Identification
The device can be identified by the label's data
(ordering code, serial number). This information is
listed in the delivery document. For technical
features of the product, refer to the technical
catalogue.
3 Installation
Install the device according to the protection level
provided. Protect the system against knocks,
friction, solvents and respect the environmental
characteristics of the product.
4 Mounting recommendations
Push the display into the cut&out (approx. 92 x 68
mm
2
) without panel clips.
Install panel clips on the display's housing and
screw until fixed.