IFS-10-PM programming & display unit
4 - Electrical connections
WARNING
Power supply must be turned off before performing any electrical connection!
4.1 8-pin male connector
IFS-10-PM rear view
Figure 3
8-pin male connector
The 8-pin male connector electrically connects
the IFS-10-PM to the safety unit. For
information on the mechanical installation
refer also to the “3.3 Mounting the display unit
on the IFS-10 safety unit” section on page 12.
After initialization, parameters can be loaded,
edited and saved via the key panel (see the “5 -
Parametrization of the safety unit” section on
page 15).
WARNING
If the seal is damaged the warranty expires.
MAN IFS-10-PM EN 1.1.odt
4 - Electrical connections
14/44
