IF52
7 - Extended functions with PC set-up
For normal use in standard applications, the unit is ready to work after correct
wiring and setting of the DIL switches. If this is the case, you can jump the
following section.
Anyway, using a PC and our operator software OS3.x the full set of functions for
setting up the unit is available. You can download this software and full
instructions, free of charge, from Lika Electronic website at the address
www.lika.biz.
•
Connect your PC to the converter using a serial RS-232 cable having the
wire connection as shown in section “5.6 Serial interface“ on page 38.
•
Start the OS3.x software, then the following screen will appear:
•
In case your text and colour fields remain empty and the headline shows
the message OFFLINE, then you must check your serial settings. To do
this, press the COMMS command in the menu bar. Ex factory, the unit
features the following serial standard settings:
Unit No. 11, Baud rate 9600, 1 start/ 7 data/ parity even/ 1 stop bit
•
If the serial settings of the unit should be unknown, you can run the
SCAN function from the TOOLS menu to find out them.
MAN IF52 I_E 1.1.odt
7 - Extended functions with PC set-up
40 / 60