Lika EMC58 MT, User Manual

Page: 33 / 104

EM58 – HS58 - HM58 MODBUS TCP/IP
5 Quick reference
5.1 Getting started
The following instructions are provided to allow the operator to set up the
device for standard operation in a quick and safe mode.
•
Mechanically install the device;
•
execute the electrical connections;
•
if required, set the communication parameters to allow the unit to access
the MODBUS TCP/IP network, see the “4.5 Setting the IP address and the
network configuration parameters” section on page 28; the default
network configuration parameters are as follows:
IP Parameter Value
IP address 192.168.1.10
Subnet mask 255.255.255.0
Default Gateway 0.0.0.0
•
switch on the +10Vdc +30Vdc power supply;
•
if you need to use the physical resolution of the unit, please check that the
Scaling function item is disabled (the bit 0 in the Operating parameters
[109-110]
registers = 0; see on page 58); the encoder will use the
Singleturn resolution [113-114]
and the
Number of revolutions
[115-116]
register values to arrange the absolute position information;
•
otherwise if you need a specific resolution, please enable the
Scaling
function
item (the bit 0 in the
Operating parameters [109-110]
registers = 1; see on page 58);
•
then set the value you need for the singleturn resolution next to the
Counts per revolution [101-102]
registers, see on page 53;
•
set the value you need for the overall resolution next to the
Total
Resolution [103-104]
registers, see on page 54;
•
now, if you need you can set a Preset value next to the
Preset value
[105-106]
registers and then activate it by executing the
Perform
counting preset
command available in the
Control Word [111-112]
registers, see on page 56;
•
save the new setting values (use the
Save parameters
command available
in the
Control Word [111-112]
registers, see on page 60).
NOTE
MODBUS TCP/IP protocol does not require any configuration file.
MAN EM58_HS58_HM58 MT E 1.1.odt Quick reference 33 of 104