AMM80 • SSI, BiSS, & RS-485
WARNING
Now you are required to replace the battery
within 60 seconds
!
4. install and connect the new
battery;
5. switch the 5Vdc power supply
off;
6. switch the 5Vdc power supply
on;
7. the singleturn and multiturn positions are provided properly (the
position is exactly the same the encoder was in when you stopped it);
8. if you turn the disk, both WARNING and ERROR LEDs are off.
4.5.2 Replacement of the battery – ERROR active
NOTE
Follow this procedure if, at power-on, the ERROR bit and/or the ERROR LED are
active.
1. Stop the disk at any point;
2. switch the 5Vdc power supply off;
MAN AMM80 SSI_BiSS_RS485 E 1.5.odt
4 - Electrical connections
26 of 60
