AMM5A & AMM5B • SSI, BiSS, & RS-485
•
do not disassemble the encoder;
•
do not tool the encoder or the disk/ring;
•
delicate electronic equipment: handle with care; do not subject the device
and the disk/ring to knocks or shocks;
•
respect the environmental characteristics declared by manufacturer;
•
the encoder must be adequately protected under an enclosure appropriate
for the specific application.
1.4 Specific handling and cleaning instructions and safety information
against electrostatic discharges
Please be sure to strictly observe the following safety precautions and
instructions before handling and installing the kit encoder.
•
Open the box and handle the electronic components only within an EPA
(Electrostatic Protective Area) and when you are properly grounded;
•
before handling the kit encoder the operator must wear:
-
a wrist strap; it must be worn on the hand and connected to ground
through a 1 megohm resistor;
-
an ESD smock made of dissipative material;
-
dissipative gloves; they are further used not to dirty the code disk while
mounting;
•
always handle the encoder by grasping the enclosure on the sides;
•
the code disk must always be handled by grasping its outer edges or the
magnetic ring;
•
avoid flexing the disk, exposing it to direct sunlight, excessive heat and/or
humidity;
•
if dust or fingerprints get on to the disk, wipe with a soft dry cloth or camera
lens tissue; wipe the disk using circular motions; more stubborn fingerprints
or stains can be removed using a soft cloth lightly moistened with a few
drops of alcohol; do not use gasoline, kerosene, benzene or other solvents, as
they damage the disk.
MAN AMM5A_B SSI_BiSS_RS485 E 1.9.odt
1 - Safety summary
9 of 56
