AMM5A & AMM5B • SSI, BiSS, & RS-485
3.3 Mounting the code disk
WARNING
•
The encoder must be adequately protected under an enclosure
appropriate for the specific application;
•
before installation, carefully clean the code disk from dust or
fingerprints, wipe it with a soft dry cloth or camera lens tissue; wipe the
disk using circular motions; more stubborn fingerprints or stains can be
removed using a soft cloth lightly moistened with a few drops of
alcohol; do not use gasoline, kerosene, benzene or other solvents, as
they damage the disk;
•
the code disk must always be handled by grasping its outer edges or the
magnetic ring;
•
protect the disk from scratching;
•
avoid flexing the disk;
•
always handle the encoder unit by grasping the enclosure on the sides;
•
keep magnets away from the magnetic ring in the code disk, it could be
damaged by strong magnetic fields.
Step 1
Place the
PF5019
spacing tool
1
against the shaft
2
. Insert the code disk
3
into the shaft
2
and lay it down on the spacing tool
1
; always handle the code
disk
3
by grasping its outer edges or the magnetic ring.
MAN AMM5A_B SSI_BiSS_RS485 E 1.9.odt
3 - Mounting instructions
16 of 56
