AM58K CANopen®
4.4 Connection cap with M12 connectors
The connection cap has two M12 connectors with pin-out in compliance with
CANopen
®
standard. Therefore you can use standard CAN cables commercially
available.
M12 connector
A coding
(frontal side)
male
(BUS IN)
female
(BUS OUT)
M12
Description
Case
CAN Shield
1
1
2
+10Vdc +30Vdc Supply voltage
3
0 Vdc Supply voltage
4
CAN High
5
CAN Low
1
CAN Shield is also connected to pin 1 to allow the connection
of the shield even if the plug connector has a plastic case.
4.5 Connection of the shield
Disentangle and shorten the shielding
1
and then bend it over the part
2
; finally
place the ring nut
3
of the connector. Be sure that the shielding
1
is in tight
contact with the ring nut
3
.
MAN AM58K CB E 1.1.odt
15
4 - Electrical connections
