NOTE: Learning Mode lasts for only 5 seconds; if no
signal is received from a remote handset during this
time then the adapter will automatically exit learning
mode without pairing the device.
Unpairing Remotes and clearing the Switch
memory
Removing single device:
1. Remove the plug adaptor from the wall socket and
after 5 seconds replace it.
2. Once plugged into the wall the adaptor will enter
LEARNING MODE for a duration of 5 seconds, this will
be illustrated by the red LED flashing on and off.
3. Whilst the adaptor is in leaning mode, on the
Remote press the ‘OFF’ buttons of the paired channel
that needs to be unpaired; the LED on the adaptor will
stop blinking and any lamp plugged in and turned on
will flash twice to indicate that it is un-paired.