Page 20 / 43
Section 4. Programmers reference
4.4.11. Configure remote alerts
Description
: The device logs different levels of errors. Configure which level of errors
has to be sent out as an alarm message.
Format
Example
Command
{ELEVELSEND#<p>=
<0>,<1>,<2>,<3>,<4>}
→ {ELEVELSEND#1=0,0,1,1,1}
Response (ELEVELSEND#<p>=
<0>,<1>,<2>,<3>,<4>)CrLf
← (ELEVELSEND#1=0,0,1,1,1)CrLf
Explanation:
The device will send an immediate message on all control interfaces when
a ‘matter’, ‘error’ or ‘fatal’ level error occurs.
Legend:
<p>: Adjusted control interface must be 1 = RS-232
<0>:
‘Notice’ level events
0 = no immediate message send
1 = immediate message
<1>:
‘Warning’ level events
0 = no immediate message send
1 = immediate message
<2>:
‘Matter’ level events
0 = no immediate message send
1 = immediate message
<3>:
‘Error’ level events
0 = no immediate message send
1 = immediate message
<4>:
‘Fatal’ level events
0 = no immediate message send
1 = immediate message
See section
4.4.10
on page
19
for more information about error levels.
4.4.12. Query level of remote alerts
Description
: User can check which level of errors has to be sent out as an alarm
message.
Format
Example
Command {ELEVELSEND#<p>=?}
→ {ELEVELSEND#1=?}
Response (ELEVELSEND#<p>=
<0>,<1>,<2>,<3>,<4>)CrLf
← (ELEVELSEND#1=0,0,1,1,1)CrLf
Legend:
Please read section
4.4.11
on page
20
.
Explanation:
The device will send an immediate message on all control interfaces when
a ‘matter’, ‘error’ or ‘fatal’ level error occurs.
4.4.13. Set the priority settings
Description
: This command sets the video priority mode.
Format
Example
Command {VIDEOPRIORITY=<pmode>}
→ {videopriority=1}
Response (VIDEOPRIORITY=<pmode>)CrLf
← (VIDEOPRIORITY=1)CrLf
Legend:
<pmode>
Two kinds of video priority modes can be:
<0>
First detect
First the device check the HDMI than the VGA
video input port. That port will be selected which
contains valid video signal.
<1>
HDMI priority
If there is a valid signal on the HDMI input, these
port always will be selected, even if the active port
was the VGA input port.
Explanation:
The device uses HDMI priority in video autoselect mode.
Summary of Contents for UMX-TP-TX100R
Page 1: ...UMX TP TX100R Programmer s Reference Manual ...
Page 2: ......
