6. Lightware Device Controller (LDC)
series – Extender Application Mode – User's Manual
82
6. Lightware Device Controller (LDC)
series – Extender Application Mode – User's Manual
82
EXTENDER APPLIC
A
TION MODE
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
6.7. Properties Windows - Audio Layer
6.7.1. Analog Audio Input Port
Clicking on the
Analog in
port icon of the transmitter, receiver, or transceiver results opening the Port
properties. The most important signal and display information and settings are available on the panel:
Port properties window of the Analog in (TX)
Available settings and tools:
▪
Port naming;
▪
Volume
: sets the input volume (attenuation) between 0% (-95.62 dB) and 100% (0 dB). Clicking on the
icon results -1%, the
icon r1% in the volume setting. The default value is 100%.
▪
Balance
: sets the balance between -100 (total left) and 100 (total right). Clicking on the
icon results
-1, the
icon r1 in the balance setting. The default value is 0 (center).
▪
Gain
: sets the gain between -12 dB and 35 dB. Clicking on the
icon results -1 dB, the
icon results
+1 dB in the gain setting. The default value is 0 dB.
▪
Reloading factory default settings
for the selected port.
#analogaudio #volume #balance #gain
6.7.2. Analog Audio Output Port
Clicking on the
Analog out
port icon of the transmitter, receiver, or transceiver results opening the Port
properties. The most important signal and display information and settings are available on the panel:
Port properties window of the Analog out (RX)
Available settings and tools:
▪
Port naming;
▪
Volume
: sets the input volume (attenuation) between 0% (-95.62 dB) and 100% (0 dB). Clicking on the
icon results -1%, the
icon r1% in the volume setting. The default value is 100%.
▪
Balance
: sets the balance between -100 (total left) and 100 (total right). Clicking on the
icon results
-1, the
icon r1 in the balance setting. The default value is 0 (center).
▪
Mute
: enable or disable the muting of the output port.
▪
Reloading factory default settings
for the selected port.