Lightware UBEX-PRO20-HDMI-F100, User Manual, Page: 27 / 185

3. Front Panel LCD Menu Operations series – Extender Application Mode – User's Manual 27 3. Front Panel LCD Menu Operations series – Extender Application Mode – User's Manual 27
EXTENDER APPLIC
A
TION MODE
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
Stream Output
The following settings and information is related to the video stream which is sent toward the remote TRX
endpoint:
▪
Stream enable
- Enabled / Disabled #streamenable
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space
3.6.2. L (Local) TRX O1 Port
Stream Input
The following settings and information are related to the video stream coming from the input port of the
remote TRX endpoint:
▪
Stream enable
- Enabled / Disabled #streamenable
▪
Signal present
▪
Active resolution
▪
Total resolution
▪
Color space
Video Settings
The following settings can be set for the stream of the HDMI output 1 port:
▪
Resolution mode
#scaler
– Passthrough: pass-through mode; the original resolution of the stream is transmitted.
– Forced: the resolution which is set in the Resolution setting menu is forced.
– EdidBased: the resolution which is read out from the EDID of the connected sink device is forced.
▪
Resolution setting
- select a resolution to force from the pre-installed list. The entire list can be found in
the Resolutions of the Scaler / FRC section.
▪
Image position
- Center / Fit / Stretch
▪
Color space
- Passthrough / Force RGB / Force YCbCr 4:4:4 / Force YCbCr 4:2:2 #csc #colorspace
▪
No sync mode
- the No sync mode feature generates an image which can be displayed when there
is no incoming signal on the port. The following settings can be set for the Test Pattern function:
#testpattern #nosyncscreen
–
Always off
- the test pattern function is disabled, the video output port transmits the video signal of
the selected input port.
–
No signal mode
- the video output port transmits the test pattern if there is no incoming signal on
the selected input port.
–
Always on
- the video output port always transmits the test pattern.
–
Freeze
- the signal freezes at the last video frame on the sink device (the sink may show a broken
frame either). #freeze
HDMI Output
The following information are displayed for the HDMI output 2 port of the transceiver: #hdcp #power5v
▪
HDCP mode
- Auto / Always / Force 2.2 Type1
▪
Output 5V mode
- Always on / Auto / Always off
▪ Hotplug detect
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space
3.6.3. R (Remote) TRX I2 Port
The following information is related for the HDMI input port of the connected remote transceiver.
HDMI Input
▪ +5V present
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space
Stream Output
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space
3.6.4. R (Remote) TRX O1 Port
The following information is related for the HDMI output port of the connected remote transceiver.
Stream Input
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space
HDMI Output
▪ Hotplug detect
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space

  

  