Lightware UBEX-PRO20-HDMI-F100, User Manual, Page: 24 / 185

3. Front Panel LCD Menu Operations series – Extender Application Mode – User's Manual 24 3. Front Panel LCD Menu Operations series – Extender Application Mode – User's Manual 24
EXTENDER APPLIC
A
TION MODE
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
3.4. Ports Menu - Transmitter Operation Mode
The most important settings and status information of the HDMI ports are
available in the Ports menu.
The four local HDMI ports and the remote HDMI ports of the connected device
are listed in the Ports menu of the transmitter.
INFO: The displayed remote ports depend on the operation mode of the
connected remote device. It is different when the connected device is a
receiver or a transceiver.
Local ports
Remote ports if the connected
device is RECEIVER (RX)
Remote ports if the connected
device is TRANSCEIVER (TRX)
TX I1 RX O1 TRX I2
TX I2 RX O2 TRX O1
TX O1
TX O2
Select the desired input or output port and enter to see the submenus.
3.4.1. TX I1 and TX I2 Ports
HDMI Input
The HDCP setting and information about the HDMI inputs are displayed:
▪
HDCP enable
- Enabled / Disabled #hdcp
▪ +5V present
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space
Video Settings
The following settings can be set in the case of both input ports:
▪
Resolution mode
#scaler #frc
– Passthrough: pass-through mode; the original resolution of the stream is transmitted.
– Forced: the resolution which is set in the Resolution setting menu is forced.
▪
Resolution setting
- select a resolution to force from the pre-installed list. The entire list can be found in
the Resolutions of the Scaler / FRC section.
▪
Image position
- Center / Fit / Stretch
INFO: The Image position setting on the HDMI in 2 port is a read-only parameter and fixed as "Center".
▪
Color space
- Passthrough / Force RGB / Force YCbCr 4:4:4 / Force YCbCr 4:2:2 #csc #colorspace
Stream Output
The following settings and information are related to the video stream sent toward the remote RX endpoint:
▪
Stream enable
- Enabled / Disabled #streamenable
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space
3.4.2. RX O1 and RX O2 Ports
INFO: The following port status information is related to the remote output ports of the receiver.
Stream Input
The following information is displayed in the case of both streams transmitted to the receiver:
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space
HDMI Output
The following information is displayed in the case of both output ports of the receiver:
▪ Hotplug detect
▪ Signal present
▪ Active resolution
▪ Total resolution
▪ Color space

  

  