11. Assembly Guides
series – Extender Application Mode – User's Manual
153
11. Assembly Guides
series – Extender Application Mode – User's Manual
153
EXTENDER APPLIC
A
TION MODE
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
11.1. Front Plate Exchange for F-series Endpoint Devices
The section is about the assembling of the UBEX F-series endpoint devices which contains detailed step-by-
step guides and the tool requirements.
Affected Models
The front plate can be changed on the following endpoint models:
▪
UBEX-PRO20-HDMI-F100
▪
UBEX-PRO20-HDMI-F110
11.1.1. Tool Requirements
Plastic spudger tool
1.3 mm hex wrench (Allen) key
PZ1 screwdriver
11.1.2. The Steps of the Front Plate Exchange
Removal of the Front Plate
Step 1.
Remove the
rubber ring
carefully from the jog dial knob using the plastic spudger tool.
Step 2.
Find the screw in the side of the jog dial knob and use a
1.3 mm hexagon (Allen) wrench key
to loosen it.
Step 3.
Pull down the jog dial knob from the holder.
Step 4.
Remove all the
six screws
from the front plate using the PZ1 screwdriver.