Lightware RAP-B511-EU-K, User Manual, Page: 43 / 73

6. LW2 Programmer's Reference RAP-B511 series – User's Manual 43
6.5. LW2 Commands – Quick Summary
General LW2 Commands
Operation
See in
chapter
Command
View Product Type 6.2.1 {I}
View Device Label 6.2.2 {LABEL}
Query Control Protocol 6.2.3 {P_?}
View Firmware Version of the Package 6.2.4 {F}
View Firmware for All Controllers 6.2.5 {FC}
Connection Test 6.2.6 {PING}
View Serial Number 6.2.7 {S}
Compile Time 6.2.8 {CT}
View Installed Board 6.2.9 {IS}
Restart the Device 6.2.10 {RST}
Query Health Status 6.2.11 {ST}
Restore Factory Default Settings 6.2.12 {FACTORY=ALL}
Network Configuration
Operation
See in
chapter
Command
Query the Current IP Status 6.3.1 {IP_STAT=?}
Set the IP Address 6.3.2 {IP_ADDRESS=<type>;IP_ADDRESS}
Set the Subnet Mask 6.3.3 {IP_NETMASK=<subnet_mask>}
Set the Gateway Address 6.3.4 {IP_GATEWAY=<gateway_address>}
Apply Network Settings 6.3.5 {IP_APPLY}
GPIO Configuration
Operation
See in
chapter
Command
Set Level and Direction for Each Pins 6.4.1 {GPIO<pin_nr>=<dir>;<level>}
  
