3. Front Panel Control
Hybrid Modular Matrix Switcher series – User's Manual
23
Applied firmware package: v1.0.0 | LDC software: v2.4.0b3
Disconnecting or Muting in Take Mode
Step 1.
Press and release the selected
source
button. The pressed source button and all
destination buttons which are currently
connected to this source will light up.
Step 2.
Press and release the desired green lighting
destination
button. The pressed destination
or multiple destinations will turn dark.
Step 3.
Press and release
Take
button to execute
disconnection.
INFO:
Deselected destinations are disconnected
from any source, thus output devices will
display black image or no signal message, or
automatically will turn off.
Changing Connections in Autotake Mode
Step 1.
Press and release the desired
destination
button. The pressed destination button
and the actually connected source button
light up green. If no source is connected
(the output is muted) no source button will
light up.
Step 2.
Press and release the desired
source
button. Switching is executed immediately.
Switching between sources to the selected
destination can be done directly.
Disconnecting or Muting in AUTOTAKE Mode
To prevent accidental muting this action is inhibited
(disabled) in Autotake mode. Pressing a source button twice would cause accidental disconnecting.
#crosspoint #switch #autotakemode
3.1.4.
Preset Operations
DEFINITION:
A
preset
stores a configuration regarding all input
connections and mute state for all outputs.
INFO:
The matrix switcher has 24 user programmable
presets. All presets are stored in a non-volatile
memory; the router keeps presets even in the case of a power down. Memory numbers are assigned to
source buttons 1 to 24. If the frame has fewer buttons, the higher numbered presets are accessible only
through software control.
Saving a Preset in Take Mode
#preset
Create the desired connections which have to be
saved.
Step 1.
Press and release the
Save preset
button.
Step 2.
Press and release a
source
button
according to the desired memory address
(source 1 to 24).
Step 3.
Press and release the
Take
button. Now
the current configuration is stored in the
selected memory.
ATTENTION!
Preset save action always stores
the current
configuration for all outputs including
mute state, but ignoring lock state.
Loading a Preset in Take Mode
Step 1.
Press and release the
Load Preset
button.
Step 2.
Press and release a
source
button
according to the desired memory address
(source 1 to 24).
Step 3.
Press and release the
Take
button. Now the
selected preset is loaded.
ATTENTION!
Loading a preset modifies all
output states that are not currently locked.
