5. Software Control – Lightware Device Controller
MMX6x2-HT series – User's Manual
37
5.8.5.
Creating an EDID
Since above mentioned Advanced EDID Editor needs more complex knowledge about EDID, Lightware
introduced a wizard-like interface for fast and easy EDID creation. With Easy EDID Creator it is possible to
create custom EDIDs in four simple steps. By clicking on the
Create
button below the left panel, Easy EDID
Creator is opened in a new window.
Easy EDID Creator Wizard
5.9.
Control Menu
The menu gives the opportunity to set the interfaces which can be used to connect or control third party
devices.
5.9.1.
RS-232 Tab
Control Menu, RS-232 Tab
The following settings and functions are available (both on local and TPS serial ports):
▪
Operation mode: Control, Command Injection, or Disconnect (for more details about serial interface
modes see the
section);
▪
Baud rate: 4800, 7200, 9600, 14400, 19200, 38400, 57600, 115200;
▪
Data bits: 8 or 9;
▪
Parity: None, Odd, or Even;
▪
Stop bits: 1, 1.5, or 2;
▪
Command injection: enable or disable; port number;
▪
Control protocol: LW2 or LW3;
▪
Message sending via serial port;
▪
Reloading factory defaults (see factory default settings in the
section).
