Lightware MMX4x2 Series, User Manual

Page: 44 / 172

5. Software Control - Lightware Device Controller MMX4x2 series – User's Manual 44
Applied firmware package: v1.6.0b19 | LDC software: v2.5.13b5
5.5.3. HDMI Video Output
Port properties window of the HDMI video output
Available settings and tools:
▪
Mute/unmute the port;
▪
Lock/unlock the port;
▪ Autoselect
settings (see below)
▪ Signal type
: Auto / DVI / HDMI - The outgoing signal format can be selected from a drop-down menu;
▪ HDCP mode
: Auto / Always - The transmitter forces the source to send the signal without encryption if
the content allows when Auto mode is selected; #signaltype #hdcp
▪ Connected source
▪ Power 5V mode
: Auto / Always on / Always off - The setting lets the source and the sink devices be
connected – independently from the transmitted signal;
▪ No sync screen
: configuration settings of the test pattern. See more details in the No Sync Screen (Test
Pattern) section.
▪ Frame detector
diagnostic tool (see the Frame Detector section);
▪
Send and receive Consumer Electronics Control (CEC) commands by the CEC Tool,
▪
Reloading factory default settings for the selected port.
Autoselect Settings #autoselect
Pay attention to the following settings for the proper operation of the Autoselect function:
– Be sure that no input is set to the same priority number;
– Be sure that all priority values are filled in (no empty space);
– Be sure that all inputs are enabled with the green tick on the right side;
– Always click on the
Set priorities
button after the changes to launch the new settings.
– Set the Autoselect settings to
Enabled
;
(See more details about the feature in The Autoselect Feature section).
   