7.2.9. Restart the device
Description
: The device can be restarted without unplugging power.
Format
Example
Command {RST}
Response
{RST}
Explanation
: The device reboots; no response is sent in this case.
7.2.10. Query health status
Description:
Internal voltages and measured temperature values are shown.
Format
Example
Command {ST}
Response (ST●<DESC>)CrLf
{ST}
(ST CPU 1.29V 1.89V 3.26V 3.30V
4.99V 50.89C 50.89C)CrLf
7.2.11. Restore factory default settings
Description
: Settings can be reset to factory default values as follows:
Format
Example
Command {FACTORY=ALL}
Response (FACTORY ALL…)CrLf
{factory=all}
(FACTORY ALL…)CrLf
Explanation
: All settings and parameters are reset to factory default, see the table in
on page
7.3. Port and crosspoint settings
7.3.1. Switch one input to one output
Following commands with <A/V/AV> option can take effect in multiple layers, according to
their parameters. Depending on ‘A’ or ‘V’ it can change only the Audio or only the Video
layer; or ‘AV’ changes both.
INFO
<A/V/AV> option usually can be skipped for legacy purposes. In this case, the devices
change all (Video & Audio) layers but using status commands it displays information about
only the Video layer. Please use AV option, when available.
Description
: Switch input <in> to output <out>.
Format
Example
Command {<in>@<out>●<layer>}
Response (O<out²>●I<in²>●<layer>)CrLf
{1@2 av}
(O02 I01 AV)CrLf
Explanation
: I2 audio and I2 video input ports are switched to O1 output port.
Legend
:
<layer>
Layer
A
Audio layer
V
Video layer
AV (or nothing)
Audio & Video layer
HDMI-3D-OPT-TX200 series
User’s manual
LW2 programmers' reference
Page 51 / 106