6.4.4. Autoselect settings
The autoselect feature can be set on fiber
link out or HDMI local out properties panel as
follows:
See more information about the Autoselect modes in section
on page
Input properties
The available input ports are listed; each one has its own priority number (equal numbers
are allowed). If you want to disable a port from the priority list, uncheck the setting next to
the priority number and the priority number will be emptied and disabled. A smaller number
means higher priority as usual. Priority 31 is the lowest priority, in this case, the port will not
be checked and cannot be selected.
Always press the
Set priorities
button after the modification to store the settings.
6.4.5. Frame detector
The ports can show detailed information about the signal like blanking intervals and active
video resolution. This feature is a good troubleshooter if compatibility problems occur
during system installation. To access this function, open the port properties window and
click on Frame detector button.
Frame detector window
A
Frame detector
Page 34 / 106
Software control