<out>:
O1 or O2 output port
<in>:
Input port. The port numbering is different in the devices. See the
on page
ATTENTION!
The response of this command does not show if the output is muted. To check the mute
status a separate query has to be used like {VC}. See section
. To
achieve multiple switches executed together, see section
on page
INFO
In this case, the outputs are linked; the change will affect both local and fiber optical output
ports.
7.3.2.
Mute specified output
Description
: Mute output <out>. The output signal is turned off.
Format
Example
Command {#<out>●<layer>}
Response (1MT<out²>●<layer>)CrLf
{#01 A}
(1MT01 A)CrLf
Explanation
: O1 audio port is muted.
ATTENTION!
Muting does not change the crosspoint’s state but disables the output itself. This way the
last connection can be easily restored with an unmute command. Switching a muted output
does not unmute the output.
7.3.3.
Unmute specified output
Description
: Unmute output <out>.
Format
Example
Command {+<out>●<layer>}
Response (0MT<out²>●<layer>)CrLf
{+01 A}
(0MT01 A)CrLf
Explanation
: O1 audio port is unmuted.
INFO
Unmuting an output makes the previous connection active as the crosspoint state has not
been changed by the muting command, only the output was disabled.
7.3.4. Lock the output
Description
: Lock an output port. Output’s state cannot be changed until unlocking.
Format
Example
Command {#><out>●<layer>}
Response (1LO<out²>●<layer>)CrLf
{#>01 A}
(1LO01 A)CrLf
Explanation
: O1 audio output port is locked.
Legend
: See section
on page
.
Page 52 / 106
LW2 programmers' reference