11. Appendix
HDMI-3D-OPT series – User's Manual
93
11.4. Content of Backup File
The backup file contains numerous settings and parameters saved from the device. When the file is uploaded
to a device, the followings will be overwritten:
HDMI input port(s)
Video port name, Audio port name, HDCP setting
DP input port
Video port name, Audio port name, HDCP setting
DVI-D input port
Video port name, Audio port name, HDCP setting
Analog audio input ports
Volume, Balance, Gain, Port name
Crosspoint settings
Audio autoselect settings, Mute ports, Lock ports, Switch ports
Video autoselect settings, Mute ports, Lock ports, Switch ports
Optical output port
Video port name, Audio port name
Test pattern mode, clock source, and type
HDCP mode, HDMI mode
RS-232 mode, Control protocol, CI port number, Port name
Remote port name, Enabled/Disabled setting
Local output port
Port name, HDCP mode, HDMI mode, Power +5V mode
Test pattern mode, clock source, and type
Serial port
RS-232 mode, Control protocol, Baud rate, Data bits, Stop bits, Parity
Port name and CI (Command Injection) port number
Network settings (only for SW4-OPT-TX240RAK model)
DHCP status (enable / disable)
Static IP address, Network mask, Gateway address
Further settings
GPIO port names, directions (input/output), and levels (high/low)
User EDID data (Transmitter: U1-U14; Receiver: U1-U15)
Event manager: settings of all Events (E1-E20)
For the description of backup/restore procedure see the
Configuration Cloning (Backup Tab)
11.5. Maximum Fiber Cable Extensions
OM1
OM2
OM3
OM4
(62.5/125)
(50/125)
(50/125)
(50/125)
1080p@60Hz 24 bpp
250 m
600 m
1200 m
2500 m
1080p@60Hz 36 bpp
150 m
400 m
800 m
1300 m
4096x2048@30Hz 24 bpp
Not supported
350 m
700 m
1100 m
