5.SoftwareControl-LightwareDeviceController
HDMI-TPS-RX110AYseries–User'sManual
45
Appliedfirmwarepackage:v1.5.0b3 | LDCsoftware:v2.5.9b2
TCP Clients (TCP Message Recognizer)
DIFFERENCE:
ThisfeatureisavailableonlyinHDMI-TPS-RX110AY-PlusmodelfromFWpackagev1.5.0b3.
This tab is the preparing and monitoring interface for the TCP recognizer which may trigger Event Manager
Actions. A simple example can be seen in the
section.
TCP Clients tab in the Control/Ethernet menu
ThetargetdevicehastobesetasaTCPclient(threeclientscanbeset):
Step 1.
Type and set the
Target IP address
.
Step 2.
Type and set the
TCP port number
.
Step 3.
Make sure the same
TCP port is opened
and Enabled in the target device.
Step 4.
Press the
Connect to target
button.
Step 5.
Make the target device send a message and check it in the Detected messages list.
▪
Auto reconnect:
Numeric value; sets the time (seconds) between the automatic reconnections.
▪
Delimiter:
Whenthedelimiterhexstringisdetectedintheincomingdata,themessageissavedfrom
thefirstbituntilthedelimiter(orthedatabetweenthetwodelimiters).
▪
Timeout:
If there is no response within the set time interval (milliseconds), the data will be accepted,
that is received from the last delimiter.
▪
Trigger Action:
If data is received that is closed with the recognized delimiter, an Action can be run. Type
the number of the Event (without letter 'E').
#tcprecognizer #message
SalvoHttp Status Page (Receiving HTTP Message)
DIFFERENCE:
ThisfeatureisavailableonlyinHDMI-TPS-RX110AY-PlusmodelfromFWpackagev1.5.0b3.
ATTENTION!
This feature means sending
HTTP
messagesfromanexternaldevicetotheLightwaredevice.
Encrypted transmission (
HTTPS
) is not supported.
Inthiscase,abatchofcommandscanbesentoverHTTPtotheLightwaredeviceforprocessing.Postthe
commandstothe<IP_address>/protocol.lw3addressandthecommandsareprocessedimmediatelyand
sequentially.
#http
ControlcommandscanbesenttotheLightwaredevice,butitisnotsuitableforqueryingaparameter/status
sincetheLW3responsesarenotsentbacktothesender.
ATTENTION!
If the
CleartextLogin(LoginSettings)
isenabledinthedevice,theloginhastobethefirst
command. No commands will be processed without a successful login. See the syntax in the
section.
SalvoHttp tab in the Control/Ethernet menu
