Lightware FP-UMX-TPS-TX120, User Manual, Page: 96 / 183

6. LW2 Programmer's Reference UMX-TPS-TX100 series – User's Manual 96
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
6.8. LW2 Commands – Quick Summary
General LW2 Commands
List of All Available LW2 Commands
ȩ
{lcmd}
View Product Type
ȩ
{i}
Device Label Query
ȩ
{label}
Query Control Protocol
ȩ
{P_?}
View Firmware Version of the CPU
ȩ
{F}
Connection Test
ȩ
{PING}
Compile Time
ȩ
{CT}
View Serial Number
ȩ
{S}
View Installed Board
ȩ
{IS}
View Firmware for All Controllers
ȩ
{FC}
Query Health Status
ȩ
{ST}
Restart the Device
ȩ
{RST}
Restore Factory Default Settings
ȩ
{FACTORY=ALL}
AV Port Settings
Switch an Input to the Outputs
ȩ
{ <in> @ <out> • <layer> }
Mute Output
ȩ
{# <out> • <layer> }
Unmute Output
ȩ
{+ <out> • <layer> }
Lock Output
ȩ
{#> <out> • <layer> }
Unlock Output
ȩ
{+< <out> • <layer> }
View Connection State on the Output
ȩ
{VC• <layer> }
View Crosspoint Size
ȩ
{getsize• <layer> }
Change the Video Autoselect Mode
ȩ
{AS_V <out> = <state> ; <mode> }
Change the Audio Autoselect Mode
ȩ
{AS_A <out> = <state> ; <mode> }
Change the Video Input Priorities
ȩ
{PRIO_V <out> = <in1_prio> ; <in2_prio> ;…; <inn_prio> }
Change the Audio Input Priorities
ȩ
{PRIO_A <out> = <in1_prio> ; <in2_prio> ;…; <inn_prio> }
Network Configuration
Query the Current IP Status
ȩ
{IP_STAT=?}
Set the IP Address
ȩ
{IP_ADDRESS= <type> ; <ip_address> }
Set the Subnet Mask
ȩ
{IP_NETMASK= <subnet_mask> }
Set the Gateway Address
ȩ
{IP_GATEWAY= <gateway_addr> }
Apply Network Settings
ȩ
{ip_apply}
Enable/disable the Ethernet Port
ȩ
{ETH_ENABLE= <switch> }
  
