5. Software Control - Lightware Device Controller
UMX-TPS-TX100 series – User's Manual
78
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
Step 2.
Set the action.
If the condition is fulfilled, the following action needs to be launched: the receiver sends a command to the
projector over the serial line:
▪
Power on
- the required command which is accepted by the projector: PWR0<CR><LF>
For this instance the command has to be closed with the <CR><LF> characters so they need to be escaped.
You can use the following format for escaping:
<command
1
><\x0d\x0a><command
2
><\x0d\x0a>...
...<command
n
><\x0d\x0a>
In the current case the command is: PWR0\x0d\x0a
Select the required parameters to set the action:
▪
Category
: RS-232;
▪
Expression
: Send RS-232 message;
▪
Port
: P1;
▪
Message
:
PWR0\x0d\x0a
Step 3.
Enable the Event.
Select the
E1 enabled
pipe in upper left corner to set the Event as launched.
INFO:
If you do not find the required category/expression/etc what you need, choose
the Advanced mode in the Wizard where the entire LW3 structure tree is available. For
example instead of signal detection you can set a specified resolution or color range
either as a condition.
5.11.
Settings Menu
5.11.1.
Status
Status tab in Settings menu
The most important hardware and software related information can be found on this tab: hardware and
firmware version, serial numbers, temperatures, operation time, and voltage information. Device label can be
changed to unique description by the
Set
button.
#label #devicelabel #status #firmwareversion #producttype
#serialnumber #miniweb #builtinweb #web
INFO:
The
Device label
is a user-editable name displayed next to the main menu. The
Product name
is a read-
only property.
Please note that the
Miniweb
-related descriptions can be found in
Identify Me Feature
Clicking on the
Identify me
button results the blinking of the status (in green) for 10 seconds. The feature
helps identifying the device itself in the rack shelf.
#identifyme