7. LW3 Programmers’ Reference
UMX-TPS-TX100 series – User's Manual
112
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
7.7.2. Query the Status of Destination Port
Command and Response
ç
GET·/MEDIA/AUDIO/XP.DestinationPortStatus
æ
pr·/MEDIA/AUDIO/XP.DestinationPortStatus=
<out1_state>
The response contains 5 ASCII characters for each port. The first character indicates the mute/lock state,
the next 2-byte long HEX code showing the current state of the output port.
Example
ç
GET /MEDIA/AUDIO/XP.DestinationPortStatus
æ
pr /MEDIA/AUDIO/XP.DestinationPortStatus=T000F
Legend
See at previous section.
Example and Explanation
T
0
0
0
F
Unlocked,
Unmuted
0 0
0 0
0 0
0 0
0 0
0 0
1 1
1 1
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Signal
presents
Connected
7.7.3. Query the Audio Crosspoint Setting
Command and Response
ç
GET·/MEDIA/AUDIO/XP.DestinationConnectionList
æ
pr·/MEDIA/AUDIO/XP.DestinationConnectionList=
<in>
Example
ç
GET /MEDIA/AUDIO/XP.DestinationConnectionList
æ
pr /MEDIA/AUDIO/XP.DestinationConnectionList=I5
I5 input port is connected to the output port.
7.7.4.
Switching Audio Input
Command and Response
#audio
ç
CALL·/MEDIA/AUDIO/XP:switch(
<in>
:
<out>
)
æ
mO·/MEDIA/AUDIO/XP:switch
Example
ç
CALL /MEDIA/AUDIO/XP:switch(I2:O1)
æ
mO /MEDIA/AUDIO/XP:switch
7.7.5. Query the Audio Autoselect Settings
Command and Response
ç
GET·/MEDIA/AUDIO/XP.DestinationPortAutoselect
æ
pr·/MEDIA/AUDIO/XP.DestinationPortAutoselect=
<out_set>
The response shows the settings of each output one by one.
Parameters
Identifier
Parameter description
Value
Parameter value
<out_set>
Two-letter code of the
Autoselect settings
1
st
letter
E
Autoselect is enabled.
D
Autoselect is disabled.
Two-letter code of the
Autoselect settings
2
nd
letter
F
First detect
: the first active audio input is selected.
P
Priority detect
: always the highest priority active
audio input will be selected.
L
Last detect
: always the last attached input is
switched to the output automatically.
S
Static
: the audio input follows the selected video
if the video signal contains embedded audio.
Example
ç
GET /MEDIA/AUDIO/XP.DestinationPortAutoselect
æ
pr /MEDIA/AUDIO/XP.DestinationPortAutoselect=EL
Explanation
EL
: the Autoselect is Enabled on output, selected mode is Last detect.
INFO:
For more information about the Autoselect feature see
section.