Lightware FP-UMX-TPS-TX120, User Manual, Page: 19 / 183

2. Product Overview UMX-TPS-TX100 series – User's Manual 19
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
2.5. Front View - FP-UMX-TPS-TX100 series
FP-UMX-TPS-TX120
FP-UMX-TPS-TX130
1
3
4
2
8
q
9
6
7
5
1
3
4
q
2
8
9
6
w
7
5
1
Input Status LEDs LEDs give feedback about the current status of the unit and input signals. See
the details in the Front Panel LEDs section. #status
2 Audio Select button Button for switching between audio sources. See the details in the Audio Select
Button section.
3 Video Select button Button for switching between video sources. See the details in the Video Select
Button section.
4
Ethernet Locking RJ-45 connector for configuring the device using Lightware Device
Controller (LDC), or updating it using Lightware Device Updater (LDU). Any
third-party control system can use this port to control the device.
5
VGA input D-SUB connector for analog video signal.
6 Audio input 3.5 mm Jack connector for asymmetric analog audio input signal.
7
Show Me button Special functions can be reached using this button (firmware update
(bootload) mode, DHCP settings, restore factory default settings, condition
launching in Event Manager ).
8 Reset button Pushing the button reboots the unit.
9
IR detector IR Detector can sense IR light which can be forwarded to the receiver side or
use for controlling functions.
q
HDMI input HDMI connector for DVI video or HDMI video and audio.
w
DisplayPort input DisplayPort connector for DisplayPort audio/video signal.
#analogaudio #audio #button #crosspoint #switch #testpattern #network #dhcp #reset reboot
#restart #nosyncscreen
  
