Lightware FP-UMX-TPS-TX120, User Manual, Page: 18 / 183

2. Product Overview UMX-TPS-TX100 series – User's Manual 18
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
2.3. Front View - WP-UMX-TPS-TX100 series
WP-UMX-TPS-TX120-US WP-UMX-TPS-TX130-US / WP-UMX-TPS-TX130-Plus-US
1
Input Status LEDs LEDs give feedback about the current status of the unit and input signals.
See the details in the Front Panel LEDs section.
2 Audio Select button Button for switching between audio sources. See the details in the Audio
Select Button section. #audio #analogaudio
3
Video Select button Button for switching between video sources. See the details in the Video
Select Button section. #crosspoint #switch
4
Ethernet Locking RJ-45 connector for configuring the device using Lightware
Device Controller (LDC), or updating it using Lightware Device Updater
(LDU). Any third-party control system can use this port to control the
device.
5
VGA input D-SUB connector for analog video signal.
6
Audio input 3.5 mm Jack connector for asymmetric analog audio input signal.
7
Show Me button Special functions can be reached using this button (firmware update
(bootload) mode, DHCP settings, restore factory default settings,
condition launching in Event Manager ). #dhcp #factorydefault
8 Reset button Pushing the button reboots the unit. #reboot #reset
9 IR detector IR Detector can sense IR light which can be forwarded to the receiver
side or use for controlling functions.
q
HDMI input HDMI connector for DVI video or HDMI video and audio.
w DisplayPort input DisplayPort connector for DisplayPort audio/video signal.
1
3
4
5
2 7
8
9
6
q
1
3
4
5
2 7
8
9
6
w
q
2.4. Rear View - WP-UMX-TPS-TX100 series
WP-UMX-TPS-TX120-US / WP-UMX-TPS-TX130-US /
WP-UMX-TPS-TX130-Plus-US
1
RS-232 connector 3-pole Phoenix connector for controlling the device with LDC or third-party
control systems, or third-party device control. Pin assignment can be found
in the RS-232 Connector section.
2 TPS output (PoE) Locking RJ45 connector for HDBaseT
TM
signal transmission. Maximum
CATx cable distances can be found in the Maximum Extension Distances
section.
3
48V DC input Power the device remotely by a PoE-compatible power injector (TPS-PI-
1P1). If the device has to be powered by a local adaptor (PSU-48VP1),
connect the output to the 2-pole Phoenix connector on the rear of the wall
plate. See more details about powering options in the 48V DC Connection
section or see all the available Powering Options .
2
3
1
  
